[British-cars] [TR] Tight Steering

[Randall]

> I am 
> highly suspicious of the aftermarket silentblocs and as I  
> recall from a previous conversation we had, that you used a 
> silentbloc that is  aftermarket with bearing surfaces rather 
> than the rubber bonded jobs that I (and  likely the lister) 
> am using.  
> Although I am not all that enthusiastic  about pulling this 
> apart again, if I am correct as to our previous conversation, 
>  can you tell me where you got these?

I got mine from British Frame and Engine (Ken Gillanders).  Not cheap, but
should last forever.  I see they are listed for $100/pair now :
http://www.britishframeandengine.com/parts1.html

I also did a bit of fitting; as I recall I added a shim to one of them (to
tighten the vertical clearance) and reamed the other one so the pin would
run smoothly after the bush was pressed into the arm.  Also added grease
zerks.  YMMV

Randall