[Bricklin] Air Lines Replacement?

[Rick at High Tech Coatings]

before you change the compressor add a new check valve between it and the
tank. you can cut one in about a foot from the one in the flex hose near the
compressor, Viair uses a shuttle type valve and corrosion can cause it to
stick causing a leak back into the compressor. I use a low crack flapper
style, they seem to work very well.

On 7/25/2014 12:48:42 AM, Greg Schroeder (gschroeder at comcast.net) wrote:
> Is there a recommended interval for replacing air door lines?  I have
> developed a slow leak that I have not been able to track down at any of
> the
> connections.  So I am wondering if it could be the air lines causing
> the
> issue.  If I let the car sit without the compressor on it will drop
> down to
> about 80 lbs. overnight.   I need a little over 100 lbs. for my doors to
> open.
> I had replaced the pump a few years back with Viair a 145 lbs. cut off
> switch.
> My original pump could not fill over 115 lbs.  I am wondering with the
> newer
> pump and higher pressure cut off it I have exceeded some of the original
> lines
> capacity.
>
> If I need to replace these can you recommend an online vendor?
>
> Greg 0036
> _______________________________________________
> Bricklin at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.
> net/mailman/options/bricklin/rick at hightechcoatings.com


---
This email is free from viruses and malware because avast! Antivirus
protection is active.
http://www.avast.com