[Bricklin] Oil Pressure

[Rick at High Tech Coatings]

 1st if you have fram filter on it remove it and replace witha WIX, Purolator
or Napa filter, If that solves your  problem great , if not you have wear in
the oil pump housing, this is a very common problem with the AMC 360 engines.
you can check the oil [pump gear clearances and add a wear plate to the end of
the pump it that is worn,  you can go and read all about amc oiling here
http://www.bulltear.com/forums/forumdisplay.php?111-AMC-oiling&s=ad684a5caa5f
0cdd722bc05543519da7


On 4/23/2011 10:13:36 PM, Greg Schroeder (gschroeder at comcast.net) wrote:
> My oil pressure is fine when I start the car and drive for a little while
> it
> will idle fine in gear, with the brake and ac on.  Even after the choke
> turns
> off it is fine  After the car gets up to temp (around 180) when I stop
> the
> idle has decreased and the oil pressure light starts to blink or stay on.
> The
> car still runs, but I would like to know if anyone knows the cause of this
> so
> I can address it.
>
> Greg 0036