[Bricklin] Car will not start. Any suggestions

Greg Schroeder gschroeder at comcast.net
Wed Apr 28 21:45:26 MDT 2010


Well I just got a backfire.  Which would make me believe the timing may be
off.  Seems like I had a similar problem after my engine rebuild and it seemed
the firing was at the opposite point of where it should have been.  I am not
sure why this would occur since I had not removed the rotor or the plug
wires.

I did notice my brake warning light was coming on when trying to start the
car.  I am not sure if that is an issue, since I had not been paying attention
to those lights when starting the car and I do not drive it that often.

I did get a new coil wire just to check and I am seeing spark from the wire to
a ground.

I went ahead and replaced the distributor since I had to go back to my old one
a few months ago when the ball at the coil wire fell out.  So I needed to
replace that anyway.

I tried to purchase a rotor cap, but the two parts stores were showing stock,
but could not locate them.  I may have to try another store tomorrow.

Greg 0036


More information about the Bricklin mailing list