[Bmcu] 57 TR3 head studs not lined up?

[Ron Christensen]

It is a common problem with all British cars . . . . block shrinkage. Take
the engine out and warm it to 1000 degrees and the gasket should slide right
on.

-----Original Message-----
From: bmcu-bounces at autox.team.net [mailto:bmcu-bounces at autox.team.net] On
Behalf Of Jeremiah Curry
Sent: Thursday, September 27, 2007 9:20 PM
To: owner-triumphs at Autox.Team.Net; bmcu at autox.team.net
Subject: [Bmcu] 57 TR3 head studs not lined up?

Howdy all,
 
I am getting ready to put the head on my TR3 for the first time since I got
it.  A few weeks ago I went to put the head gasket on and found that the
holes in the gasket didn't exactly line up with the holes studs.  I figured
the studs must be bent, so I stopped and ordered new ones.  However after
putting the new studs in I find the same problem, maybe a little less
severe, but the same problem.  I don't know if I can even get the gasket on
without tearing it to pieces.
 
Has anyone else seen this before or have any insight?
 
thanks,
Jeremiah

[demime 1.01d removed an attachment of type application/ms-tnef which had a
name of winmail.dat] _______________________________________________
Bmcu mailing list
Bmcu at autox.team.net
http://autox.team.net/mailman/listinfo/bmcu