[Alpines] Clutch compatibility
Ron Tebo
mrtebo at shaw.ca
Tue Jan 8 11:11:41 MST 2008
Andy:
I think you and Peter Chadbund have already established that you have
the slave cyl. installed on the wrong side, but I just wanted to assure
you that this is true with all of the slave cylinders, not just the 1725
models. I have an early Series I (B9000627) and had a problem on my
first brake job due to mounting the slave on the wrong side. (I have a
Series V transmission, but Series I flywheel, clutch, and T/O bearing,
so my setup is not standard either).
Glad to hear you are getting ready to race, and let us know howit goes,
no matter what result!
Ron Tebo
awtiger at cox.net wrote:
>Okay, here goes...first, the condensed version (on my Series I vintage racer):
>
>Current set-up:
>
>Series IV 1600 motor
>Series III transmission
>Series V flywheel
>Series V clutch disc and pressure plate (with roller release bearing)
>Series V bell housing and clutch actuating arm
>
>Problem: Prior to the restoration/rebuild of my race car, it had a complete Series V drivetrain in it (1725 engine, Series V transmission and a Series V clutch and bell housing). This motor was not legal for the group I run with, but a 1600 was. Consequently, I built a Series IV 1600 and installed a Series III close-ratio gearbox (legal in my group). However, I may have made a mistake by retaining the 1725 flywheel, clutch set up and bell housing. Prior to doing all of this, my clutch worked perfectly. After all the changes were made, my clutch began releasing way at the top of the pedal throw and the transmission started grinding to beat the band going into 2nd gear on a downshift from 3rd.
>
>Fact: I am using the same exact clutch that I had in the Series V drivetrain, including the roller release bearing...they were all in excellent condition.
>Fact: We have the transmission out and disassembled. The synchros, bearings, gears and shift forks appear to be in excellent condition, with the exception of 1st gear and the reverse gear cluster (leading edge of the teeth are chewed, which is not surprising as there is no synchro action for these gears)
>
>No changes were made to the clutch hydraulics, other than freshening them. I'm beginning to wonder if the cutch parts and/or bell housing and clutch actuating arm are somehow mis-matched for my application. Are there differences in the bell housings and/or the clutch actuating arm between the Series of Alpines???
>
>Given what engine/transmission/bell housing combo I have, can someone out there educate me on what pieces I need to make this all work properly? Also, since it's been a while since it all came apart, I've wondered if I have the slave cylinder mounted correctly. I mounted it with the mounting ears on the rear of the block rather than on the front. Is that correct or do I have it installed wrong?
>
>I'm trying my best to get the car sorted out for a race in February and any help would be much appreciated!!!!
>
>Thanks so much,
>__________________
>Andy Walker
>Edmond, OK
>B9006857LRX - Alpine Series I (vintage racer)
>B382001600LRXFE - Tiger Mk1A
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>Alpines at autox.team.net
>http://autox.team.net/mailman/listinfo/alpines
>
>http://www.team.net/archive
More information about the Alpines
mailing list