<div dir="ltr"><div>The rear shock conversion sold by the likes of Moss Motors, TRF, Vicky Brit, and others is likely going to result in the shock crossmember being fractured at the weld to the frame. I have fixed a few of these and this is a well known failure mode. The best practice if you are going to use these is to fashion a diagonal brace from the upper shock mount 45 deg down to the frame. I have seen some made from angle but I made a number of these from 1" thick wall tube. <br></div><div>The problem with this conversion is its to simple to attach but it imparts fore aft loads on the crossmember that causes fractures and then if fails completely and detaches from the frame.</div><div>The lever shocks do not cause fore aft loads and therefore no issues. We just had another club member suffer such a failure of the shock crossmember.</div><div>If you ever have to fix one of these your in for a treat since not only does it pull away from the frame but it tends to twist that crossmember.</div><div>This bracket should not be confused with the one TRF sold that the upper shock mount attaches to the inner rear wheel well. That one has its own issues.</div><div> Good luck with that</div><div>Glenn<br></div></div>