[6pack] Two Issues

[rmf3860 rmf3860]

Dave,

Thank you for taking the time to respond. As you suggested, I metered out
the green wires and found the one that was producing 12 volts. When I
connected it to the one of the wires in the harness connected to the trans
back up lights, THEY WORKED!

The two remaining issuers are: no turn signals, period. Hazards only flash
on he driver’s side. (Earlier I stated that I only had turn signals on the
drivers side, but I was mistaken). A new turn signal module and hazard
module should arrive this weekend. Please share any other thoughts as to
the cause(s) of these issues.

Thanks again for your help.

Bob Fabie

On Fri, Jan 28, 2022 at 7:53 AM DAVID MASSEY <dave1massey at cs.com> wrote:

> Here is a screen shot of the wiring to the transmission From Dan Master's
> handy wiring diagrams.  As you can see, there is a green wire (fused 12
> volts) to the switch and a Green/Brown wire which feeds power from the
> switch to the lights.  The Green wire should be hot anytime the key is on.
> The fuse that feeds it also feeds power to the heater fan, wipers, gauges,
> turn signals so if they work you are probably good.
>
> Turn signals: are both lights not working or is it just one?  If one bulb
> is not lighting up the other bulb will not draw enough current to cause the
> flasher to flash.
>
> On the other hand, it might just be the bulbs or bulb sockets.  The
> sockets are notoriously unreliable, especially when they get old.  The
> ground connection is the usual suspect.  Start there.  If you have a volt
> meter check for voltage on the wires where they plug onto the sockets.
>
> Dave
>
>
>
> -----Original Message-----
> From: rmf3860 rmf3860 <bobfabie at gmail.com>
> To: 6pack at autox.team.net <6pack at autox.team.net>
> Sent: Thu, Jan 27, 2022 9:09 pm
> Subject: [6pack] Two Issues
>
> Hello All,
>
> As you may know from my earlier post, by TR6 is alive and running
> beautifully following an extensive engine rebuild that ended up taking a
> few years, rather than the few months I had envisioned. Life and other
> important things interfered. Imagine that…
>
> I’m now finishing up the final details and have encountered two issues,
> probably unrelated, that I need your help in diagnosing.
>
> First: Only my left turn signal works and the hazard light doesn’t work at
> all.
>
> Second: The back-up lights don’t work. I’ve installed a new back up light
> harness. I’ve tried to study the wiring diagram but can’t quite figure out
> how the 3 wires connect to the main harness’ 3 bullet connectors in the
> passenger foot well area. I can see that two of the new harness wires are
> solid green and the other has a ?red? thread. The main harness wires are
> almost impossible to discern which are solid and which has a different
> color thread.
>
> Can anyone help me sort out these issues?
>
> Thanks.
> Bob Fabie
> Fredericksburg, VA
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
>
>
> 6pack at autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/6pack/dave1massey@cs.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20220128/8b655807/attachment.htm>