[6pack] MY fuel filler orientation

[DAVID MASSEY]

 Above is the illustration from the Roadster Factory catalog showing the tank vent routing.  As can be seen there is a tube from the connector on the filler (what is not shown but was installed on my car is another vent on the top-left-rear and another on the top-front-right of the tank, all three vents are teed together) to the fuel separator on the right side of the boot.  Another tube attached to the separator runs forward, across the top of the tank, rearward along the left side of the boot, across the boot to the right again then forward and then across the car below the tank and then down to the frame to the charcoal canister.  I guess they were really really concerned about getting any liquid gas in the charcoal and having only a few months to design and test the system they over designed it.  Works well enough as I have never had any such issues.
 

Dave (AKA anorak)

 
 
-----Original Message-----
From: Richard Lindsay via 6pack <6pack at autox.team.net>
To: TR6 <6pack at autox.team.net>
Sent: Mon, Nov 4, 2019 12:41 pm
Subject: [6pack] MY fuel filler orientation

   Thanks everyone for the advice and an interesting thread._______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums




-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20191104/09f80fd9/attachment-0001.htm>