[6pack] Carb tuning

James_ jattr6 at hotmail.com
Sat Sep 20 14:03:14 MDT 2014


Yup. Loosened the spring connectors clamps. I got them close finally. 
I'll take for a test drive (again) and see how the idle is and the dieseling is when I turn it off. Had a little run on last test. But the anti run on valve tested correctly. 
I may have them running a little rich now. But judging from the old 'lift the carb valve' test, the engine dies which says lean. I have the needles all but 3/4 turn rich! Hmm. 
Getting closer.  


bSent from my Atari 2600b

> On Sep 20, 2014, at 11:38 AM, "Mark J Bradakis" <mark at bradakis.com> wrote:
> 
> James_ wrote:
> 
>> The sync tool measures very different between the carbs. High number on the rear and lower on the front.
>> That has always been an issue to get a proper reading exact between the two.
> 
> 
> It shouldn't be that difficult to sync them. Are you loosening the clamps for both carbs from the center
> linkage before trying to balance?
> 
> mjb.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> 6pack at autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/6pack/jattr6@hotmail.com


More information about the 6pack mailing list