[6pack] Free spinning fan

[Alex]

The pulley (key) is fine. No free spin what-so-ever. The engine has been 
rebuilt and installed for over 6 years with no problem. This is a recent 
development, so I must assume everything was correct. I did the ancillary 
attachments after the long block was rebuilt and used all original parts 
where reusable. Anything needing replacement was done with Moss/TRF/VB 
replacements and matched prior to installation.
I probably won't get back to this for a week or so. I'll keep everyone 
updated. Thanks for all the input.
Alex
----- Original Message ----- 
From: "Robert Liam Gannon" <trsix74 at comcast.net>
To: "'Sally or Dick Taylor'" <tr6taylor at webtv.net>; "'Alex'" 
<ambritts at bellsouth.net>; "'*Six Pack'" <6pack at autox.team.net>
Sent: Sunday, February 07, 2010 8:11 AM
Subject: RE: [6pack] Free spinning fan


> Question: Are the correct length bolts through the fan plate and into the
> extension, being used? If not then the fan can spin freely. They must be
> able to go through the fan, adapter and extension and be tight with a 
> spring
> washer. The only other possible opportunity for it to spin, apart from 
> what
> Dick has mentioned would be that the key on the crank is missing. This
> sometimes occurs in assembly. However this would mean the timing could 
> never
> be measured or set correctly.