[6pack] Clutch/Transmission issue

Bob Danielson 75TR6 at tr6.danielsonfamily.org
Wed May 27 20:36:06 MDT 2009


 John,
I did the same thing as you with the bolts. It worked great and guided the
tranny right in. You can see how here
http://tr6.danielsonfamily.org/5SpeedEngineInstall.htm


Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org 

-----Original Message-----
From: 6pack-bounces at autox.team.net [mailto:6pack-bounces at autox.team.net] On
Behalf Of John Mitchell
Sent: Wednesday, May 27, 2009 8:38 PM
To: Darcy_Hunter at Instron.com
Cc: 6pack at autox.team.net
Subject: Re: [6pack] Clutch/Transmission issue

   The first time I installed my transmission,  I allowed the weight of the
transmission to hang briefly on the input shaft as I aligned things.  Big
mistake.  I caused the friction plate to get slightly bent and caused the
clutch to not disengage.  After that I used long(6") studs in the upper 3
holes across the top of the rear engine plate to hang the transmission on
while getting everything to slide together.  
Not sure that's your problem, but it's something to think about.  John
Mitchell  76 TR6  72 Stag

Hunter, Darcy wrote:
> No I did not Dale and in fact it was a bugger getting in until it 
> finally popped in place.  Do you think something could have come loose 
> but not showed up as a problem immediately?
>
> Darcy
>
>  
>
>   _____
>
> From: Dale [mailto:tpdwinch at yahoo.com]
> Sent: Tuesday, May 26, 2009 5:40 PM
> To: Hunter, Darcy; 6pack at autox.team.net
> Subject: Re: [6pack] Clutch/Transmission issue
>
>  
>
> Darcy
>
>  
>
> Just a question, did you use pilot bolts to support and direct the 
> transmission in place upon your last assembly?
>
>  
>
> Dale
>
>  
>
>   _____
>
> From: "Hunter, Darcy" <Darcy_Hunter at Instron.com>
> To: "6pack at autox.team.net" <6pack at autox.team.net>
> Sent: Tuesday, May 26, 2009 2:37:37 PM
> Subject: [6pack] Clutch/Transmission issue
>
> Thanks Kendall, I did go out to the garage last night and used a pry 
> bar to check the end float.  Did not use a mic but by feel, didn't 
> detect anything measureable so I'll put that in the column of reviewed but
not probable.
> Darcy
6pack at autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You are subscribed as 75tr6 at tr6.danielsonfamily.org


More information about the 6pack mailing list