[6pack] Throw Out Bearing Question

[Jim Franks]

Lou,

You need to stop the sleeve from turning on the shaft. The pins are 
meant to do that. Just take the sleeve to NAPA and have them match a 
roll pin to it.

Jim Franks

Lfm614 at aol.com wrote:
> I am going back together and ready to put the tranny on the motor.  I  bought 
> a brand new standard OEM throw out bearing assembly from TRF to  replace my 
> old one that was starting to sing.  The new sleeve does not  have the pin to 
> keep it from turning on the fork pins like the  old one, it has the little hole 
> though.  How critical is that pin?   Doesn't look like you can get one in 
> there once the sleeve and bearing are  pressed together. I did notice that my old 
> one has two notches or impressions  from the old pins up against where the pin 
> is and 180 deg out.  I thought  that maybe that is the reason the pin may 
> longer be used.
>  
> Any experience with this?  Is this assembly put together wrong?
>  
> Thanks,
>  
> Lou
>  
>  
> **************Feeling the pinch at the grocery store?  Make meals for Under 
> $10. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000002)
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> 6pack at autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> http://www.team.net/archive
>
> You are subscribed as jimmble at roadrunner.com