[6pack] J-Type Overdrive - Measurement Needed

[Navarrette, Vance]

	Mike:

	If you have a digital camera, could you post some pictures of how your mount
turns out? Might be useful for someone else in the future....

	Vance


    Vance Navarrette
    Cogito Ergo Zoom
    I think, therefore I go fast

-----Original Message-----
From: 6pack-bounces at autox.team.net [mailto:6pack-bounces at autox.team.net] On
Behalf Of Corbitt, Michael
Sent: Friday, February 20, 2009 7:55 AM
To: 6pack at autox.team.net
Subject: Re: [6pack] J-Type Overdrive - Measurement Needed

<snip>

Basically, I took measurements using my old gearbox extension (tail piece)
and
drive shaft and compared these to the configuration of the new overdrive set
up to determine that the height of the rubber bushing for the overdrive
mounting plate is the same as the height of the (1 =") gearbox mounting
bracket that is used with the 4 speed gearbox.  How simple was that?  In a
way
it seems it should have been a foregone conclusion, but not being real
mechanically inclined and without the original mounting bracket I didn't
know.
Now, if any of you later determine that I messed up my measurements and this
is not correct after all, I would appreciate the feedback.


Thanks again everybody.

Mike

Corvallis, OR