[6pack] Carpet Installation

[Foster, Stan (HP IT)]

Put the carpet in place, ie where you plan to install it etc and then stick a
bradawl or similar thin pointed tool up through the seat mounting captive nuts
under the floor. You may have to press/weight the carpet from the top to
pierce it. Then stick some masking tape onto the carpet. If you pierce the
masking tape with the point of the awl it will mark the center of the hole. I
usually just cut a small X at that location, it only has to accommodate a 1/4
inch bolt.

Stan

-----Original Message-----
From: 6pack-bounces at autox.team.net [mailto:6pack-bounces at autox.team.net] On
Behalf Of Corbitt, Michael
Sent: Tuesday, April 28, 2009 1:52 PM
To: 6pack at autox.team.net
Subject: [6pack] Carpet Installation

When laying down new carpet, what are the best methods for locating the
seat mounting holes?  It pains me to cut brand new wool carpet, and
would pain me even more to end up with swiss cheese.



Mike
6pack at autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You are subscribed as stan.foster at hp.com