[6pack] TR250 boot rubber seal

[Sally or Dick Taylor]

Andy---I have my seam at the midpoint on one side. I figured there's less chance for the trunk to have exhaust fumes getting sucked in, or water seeping in, if the seams were at the bottom or top. As it turned out, there was no shrinkage in the seal over many years, so I guess it really didn't matter.

Dick


-----Original Message-----
From: Andrew Packard
Sent: Tuesday, September 9, 2008 9:26 PM
To: '6pack List', TTSCC at yahoogroups.com
Subject: [6pack] TR250 boot rubber seal

Hi everyone:

I've been making little bits of progress each night putting my TR250 back
together.  I'm ready to install the rubber seal of the boot but I have a
question.  Should the ends come together by the latch or at the top.  I'm
guessing at the latch, but I don't remember how it was before it was
removed.  Thanks in advance for the help.

Andy

CD6746L HVDA
6pack at autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You are subscribed as tr6taylor at webtv.net