[6pack] What size thrust washers do I need?

[PeterSchop at aol.com]

I measured my crankshaft end float the other day and found it to  be just 
under .012".  I would like to get the end float closer to  .005" so I dropped the 
pan, took off the rear main bearing cap and removed the  thrust washers. What 
I found was one marked "STD" and measured at  .090" which showed a lot of 
wear and the other marked "+030" that measured  .122" and showed very little 
wear. I believe that STD should be .092" ?
 
 I have read online that the front washer should not change size  because it 
gets very little wear and you don't want to move the crankshaft  out of place. 
I have also been told that both the washers should be the same  size so to 
center the crankshaft which also makes sense. TRF sells sets of  thrust washers 
at STD, +.005", +.015" and +.030" which I believe both washers in  set are the 
same size.
 
 
Now I would like to reduce my end play from just under .012" to just  over 
.005" which means I have to add .006" to my thrust washers. In order to do  that 
I need a total of .218" with both thrust washers measured together. I like  
the idea of using Scott Helms's solid bronze thrust washer. I could have a 
.096"  made and my use my .122"  or if the front should not change I could  use a 
STD .092" and make a .0126" or if the crankshaft should be centered, have  two 
.109" made, all which would equal .218" 
 
Oh, one more thing, TRF's list at $6.95 a set and Scott's are $20 each and  
are probably worth every penny of it. If you still follow me, any comments as 
to  which way to go?

 
TIA
 
Peter Schoppelry
TR6  '69

**************Get the Moviefone Toolbar. Showtimes, theaters, movie news & 
more!(http://pr.atwola.com/promoclk/100000075x1212774565x1200812037/aol?redir=htt
p://toolbar.aol.com/moviefone/download.html?ncid=emlcntusdown00000001)