[6pack] Overvdriving gauges
Foster, Stan
stan.foster at hp.com
Sun May 18 10:15:47 MDT 2008
Pete, the voltage regulator for the instruments is a small device attached to
the back of the speedo. It is secured by a single screw and it is probably
necessary to remove the speedo to get to it.
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com at autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com at autox.team.net] On Behalf Of Pete
Kronberg
Sent: Sunday, May 18, 2008 11:20 AM
To: 6pack at autox.team.net
Subject: [6pack] Overvdriving gauges
Hey Folks,
I suspect that I've got to much voltage to my gauges- full tank pegs the
needle WAY beyond full, and when bone dry reads 1/4 tank...temp gauge reads
~25-30% too hot, etc.
Now, I understand that for the 12-volt electrics, there is a resistor(?) that
limits to 10-volts for the gauges to prevent overdriving...
Can anyone tell me more about this, and where this voltage limiter is
located?
Thanks,
Pete
CF38421U
More information about the 6pack
mailing list