[6pack] Speedi Sleeve installation

[michael lunsford]

Al,
   
  If you are installing a speedi sleeve on the crank in addition to installing a new OD transmission my recommendation would be to remove the motor (and transmission if still installed), install the speedi sleeve on the crank where it's a lot more accessable, bolt the tranny back to the motor (also a lot easier) and then reinstall them as one piece.  I used a hydraulic engine hoist with one of those angle adjustors on the chain and did it by myself in about 1/2 hour or so.  It seemed a lot simpler than the way you are contemplating.  My trans was an OD also.
   
  Mike Lunsford, 1970 TR 6 TBI.
   

       
---------------------------------
Looking for last minute shopping deals?  Find them fast with Yahoo! Search.