Where is a source for double row bearings for the MGA?
Warm Regards,
Tracy Drummond
PMP | ITIL Service Manager | CISSP | bighealey@charter.net | 408-394-3444
cell | 408-776-0133 home | http://www.linkedin.com/in/tracydrummond
-----Original Message-----
From: Sue Salsburg [mailto:old_cat@earthlink.net]
Sent: Sunday, January 10, 2010 6:10 AM
To: Tracy Drummond
Cc: vintage-race@autox.team.net
Subject: Re: [Vintage-race] MGA broken axles
Breaking at the outer flange is unusual. The normal spot is inside the
carrier, leaving a 2inch stub to beat out. Before we got serious about
upgrades, we could change the pumpkin in the pits in 45 minutes/4 beers.
Axle wrap-up on the old Sprites was so bad that racers routinely swapped
them side-to-side after each race to "untwist". Now they have after-market,
double bearing hubs. I forgot one other trick - the wire wheel axle were
"supposed to be" stronger, plus their track was a bit wider. We've always
used wire wheel axles with the splines cut off. When the street car guys
wear off the outer splines & knockoff threads, we can get them for free or
close. Good luck, Sue
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
|