Sorry, didn't realize when I forwarded this message that the address would
not go with it. Here it is
<luissaiz@cwp.net.pa>
Bob H.
----- Original Message -----
From: Luis Saiz
To: rharring@idirect.com
Cc: Luis E. Saiz
Sent: Tuesday, May 07, 2002 12:00 PM
Subject: J.17 tool
Dear Sir:
Greatings from Panama, Central America. I am looking for a cheap J,17
Churchill Tool (rear seal sizing tool) to size the rear seal on my 1967
Jaguar 420 engine currently under overhaul by myself. Or at least the
dimenssions of the tool in order to machine it here. Actually I only need
the diameter of the sizing ring in order to have the propper compression on
the seal.Could you help me out?
Yours,
Luis E. Saiz V.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/vintage-race
|