Thanks all,
I just used my spring compressor to relieve spring tension then the
entire suspension assembly could be shifted, and I was able to remove
the shims.
Lee
On 2025-11-10 06:43, Randy and Valerie DeRuiter wrote:
> Lee-
>
> After you loosen the wishbone brackets try a small pry bar between the
> lower spring plate and the frame- that should take the pressure off the
> shims and let you add or remove.
>
> Randy
> Sent from my iPad
>
>> On Nov 9, 2025, at 10:10â?¯PM, lee@automate-it.com wrote:
>>
>> Iâ??m adjusting front camber. The official method is â??slacken the nuts
>> securing lower wishbone bracketsâ?? and â??remove or add shims as
>> necessaryâ??.
>>
>> Without removing anything other than the wheel, thereâ??s only tight
>> access, and I canâ??t get the shims to budge. Any suggestions?
>>
>> Thanks,
>> Lee
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|