--===============0494794572689231730==
--000000000000a452e005ff303866
A little background. TR6s use rivets to hold the headlight buckets to the
fenders, TR4s use push-in clips and screws. I plan on eliminating the
rivets and switching to the same fasteners as were used on TR4s. The 4s
used push-in clips that reside in a square/rectangular opening. I need the
dimensions of that square/rectangular opening.
I've already got the push-in clips and one dimension is pretty obvious.
However the other is a little harder to discern what it should be and I'd
like to do it right the first time!
If someone could measure one of your spare fenders I would greatly
appreciate it.
Thanks,
Brad
--000000000000a452e005ff303866
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">A little background.=C2=A0 TR6s use rivets to hold the hea=
dlight buckets to the fenders,=C2=A0TR4s use push-in clips and screws.=C2=
=A0 I plan on eliminating the rivets and switching to the same fasteners as=
were used on TR4s.=C2=A0 The 4s used push-in clips that reside in a square=
/rectangular opening.=C2=A0 I need the dimensions of that square/rectangula=
r opening.=C2=A0<div><br></div><div>I've already=C2=A0got the push-in c=
lips and one dimension is pretty obvious.=C2=A0 However the other is a litt=
le harder to discern what it should be and I'd like to do it right the =
first time!=C2=A0=C2=A0</div><div><br></div><div>If someone could measure o=
ne of your spare fenders I would greatly appreciate it.</div><div><br></div=
><div>Thanks,</div><div><br></div><div>Brad</div></div>
--000000000000a452e005ff303866--
--===============0494794572689231730==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
--===============0494794572689231730==--
|