| To: | "john-marie@sbcglobal.net" <john-marie@sbcglobal.net> |
|---|---|
| Subject: | Re: [TR] TR4A vent lid seal |
| From: | Allen Hess <allenhess@mgcarclub.com> |
| Date: | Wed, 30 Mar 2016 07:23:01 -0400 |
| Authentication-results: | smtp01.rcn.cmh.synacor.com smtp.mail=allenhess@mgcarclub.com; spf=neutral; sender-id=neutral |
| Authentication-results: | smtp01.rcn.cmh.synacor.com header.from=allenhess@mgcarclub.com; sender-id=neutral |
| Cc: | "<triumphs@autox.team.net>" <triumphs@autox.team.net> |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | triumphs@autox.team.net |
| References: | <E4D2E44B-2D95-4B54-92EA-CF01DD824FEE@sbcglobal.net> |
| X_cmae_category: | , , a=Nh+kvCJuytLQtmZWZsSZsQ==:117 a=Nh+kvCJuytLQtmZWZsSZsQ==:17 a=L9H7d07YOLsA:10 a=9cW_t1CCXrUA:10 a=s5jvgZ67dGcA:10 a=kj9zAlcOel0A:10 a=pcLIrrrKAAAA:8 a=xzXwEhX1k8H4LTm0lEUA:9 a=CjuIK1q_8ugA:10 |
I had the same problem years ago. I resorted to trimming it too thin the profile. Allen > On Mar 29, 2016, at 6:17 AM, john-marie@sbcglobal.net wrote: > > Installed new vent lid seal. Pressed rubber fully home, but vent lid will > not close completely. Before I start trimming the seal thought I'd check > with List for similar experience and maybe a simple solution. I don't > believe additional compression from the lid will fix this. > John DeLuca > > Sent from my iPad ** triumphs@autox.team.net ** Archive: http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TR] TR6 brake master cylinder, Randall |
|---|---|
| Next by Date: | Re: [TR] TR6 brake master cylinder, rbtr3a |
| Previous by Thread: | [TR] TR4A vent lid seal, hdrider570@att.net |
| Next by Thread: | [TR] '71 GT6 Parts Needed, Chad |
| Indexes: | [Date] [Thread] [Top] [All Lists] |