...went digging.... couldn't find any specific specs for Delcos...but
Lucas mech weights have a stop as high as 14 (28 crank degrees)
ptegler
On 10/2/2014 7:05 PM, David Porter wrote:
> interesting.. the TR6's will go (as I recall) up to 36 degrees total
> advance.. I think I'll just run it up around there and see how it runs...
> dave
> On 10/2/2014 3:49 PM, ptegler wrote:
>> if you pop off the points plate, then pull the little screw in the
>> top center you can lift off the top hald of the mech adv weights
>> plate. The adv degrees number will be stamped right into the plate.
>> remember though that number is on half of the crank adv value so if
>> stamped 6 degrees it's 12 at the crank 10 would be 20 at the crank etc.
>>
>> as general info.... mech adv is usually 20 or less (usually less) a
>> the crank
>> ptegler
>>
>>
>> On 10/2/2014 5:06 PM, David Porter wrote:
>>> Anyone know what the total allowable ignition advance is for these
>>> Delco-Remy units?
>>> I'm only seeing about 15 degrees at 3000 + RPM Doesn't seem
>>> enough to me..
>>> Dave
>>
>> ** triumphs@autox.team.net **
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/triumphs/frogeye@porterscustom.com
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|