I used washers and lock washers for the seats, just lock washers for the
tracks on mine. ISTR 1/4-28x3/4" did the job.
Doors take 3/4" #4 stainless slotted sheet metal screw and cup washer. Take
great care with your drill going though the panel, if you have a small punch
that would be good.
Sent from mobile Bill
On Jul 11, 2014, at 9:52 AM, dave@ranteer.com wrote:
Getting ready to install the full interior kit on a 57 smallmouth. The
interior kit was ordered from TRF years ago. There is no hardware (nuts,
bolts, and screws).
It looks to me, from the moss catalog, that I need 16 of 323-580 for the
doors.
Then I need 8 bolts for the seat tracks. Can anyone tell me the correct
size/length and if I should put in washers or lock washers? These don't show
so I'm looking for best practice here.
I can easily measure the size but I'm particularly concerned about length and
if I should use washers. The moss pages are not helpful.
Thank you!
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|