triumphs
[Top] [All Lists]

Re: [TR] Update on stuck hood latch on my TR4A

To: triumphs@autox.team.net
Subject: Re: [TR] Update on stuck hood latch on my TR4A
From: Allen Hess <allenhess@mgcarclub.com>
Date: Wed, 4 Sep 2013 15:19:06 -0400
Authentication-results: smtp01.rcn.cmh.synacor.com smtp.mail=allenhess@mgcarclub.com; spf=neutral; sender-id=neutral
Authentication-results: smtp01.rcn.cmh.synacor.com header.from=allenhess@mgcarclub.com; sender-id=neutral
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
References: <mailman.6536.1378267262.2541.triumphs@autox.team.net>
X_cmae_category: 0,0 Undefined,Undefined a=BKmRdvKBffDVjZCHzCK0+g==:117 a=BKmRdvKBffDVjZCHzCK0+g==:17 a=K-v-2zaBAAAA:8 a=W2WgwHm10G4A:10 a=1GtspROMyXkA:10 a=kj9zAlcOel0A:10 a=rgFOHuIoAAAA:8 a=lE-apdL79DAA:10 a=OyZPjff-ZgCEstnlrikA:9 a=CjuIK1q_8ugA:10
As someone already wrote, first be sure that the pin and spring is  
centered over the latch. Then I would adjust the length of the pin on  
the long side (don't know what to tell you as I can't get to mine  
now). The pin has a screwdriver slot in the pointed end and is screwed  
into the bracket and secured with a lock nut. You'll have to pull the  
spring back or fish the wrench between the coils to loosen the nut.  
So, if the pin is adjusted to long the spring will hold it higher than  
the body. Then you can re-adjust to get the hood flush.

One other tip: one time I pulled the hood release and thought I had  
broken the cable or pulled it from the fitting. After I got it open,  
it turned out that the clip on the outer cable which holds the cable  
to the hood latch had slipped off the latch and when that happens, it  
doesn't work.

Allen
TR4 since 1967

** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>