triumphs
[Top] [All Lists]

Re: [TR] Fender Attachment TR4

To: <triumphs@autox.team.net>
Subject: Re: [TR] Fender Attachment TR4
From: "Brian Induni" <308gtsi@roadrunner.com>
Date: Mon, 27 May 2013 22:21:19 -0700
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
Thread-index: Ac5bYy03YGkyd7mAQhWgcs80prcfmw==
Hi Jim,

When I put the wings back on my TR4A, I used Butyl Rubber between the mating
surfaces. Sticky stuff (don't get it on your hands!), but pretty handy to
hold the chrome fender bead in place as you get the fender lined up. The
butyl rubber comes in a tube that pops in a caulking gun, and a little bit
goes a long way. It stays soft and flexible. I've done it this way on a lot
of other restorations I've done over the years and I will continue to do it.

Brian

------------------------------

Message: 5
Date: Mon, 27 May 2013 19:55:05 -0400
From: "James Henningsen" <trguy75@gmail.com>
To: <triumphs@autox.team.net>
Subject: [TR] Fender Attachment TR4

I am slowly getting my TR4 restoration project back together.  The factory
repair manual mentions using a sealant when installing the wings.  Has
anyone done that, if so, what did you use and what technique did you use.
The manual mentions applying to seam after wing installed from underneath.  

Thanks,

Jim Henningsen

62 TR4 CT5212LO

75 TR6

Ocala, FL


------------------------------

** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>