Geo,
Trying to install my TRF hoodstick cover and don't seem to be able to get it
right. I believe I got the two inside pegs correct based on the LTD snaps
that were already installed. But, while I put the inner pegs as high as I
could without interference from the body, they still seem too low and
conflict with the rear panel when re-installed.
I remembered you had posted some pictures, but these links seem to no longer
be working. Do you have new links?
Much appreciated,
Bill
Bill Beecher
'58 TR3A TS/30766L "Tarbaby"
'62 TR3B TCF/2549L " Aunt B" (in rehab)
www.triumphowners.com/1566
'68 Land Rover Series IIa 88" "The Beast"
"If you think you have everything under control... You're driving too slow"
M.Andretti
-----Original Message-----
From: Geo Hahn [mailto:ahwahneetr@gmail.com]
Sent: Sunday, December 05, 2010 12:58 PM
To: wbeech@flash.net
Cc: triumphs@autox.team.net
Subject: Re: [TR] Attaching aTR3A bow cover.
On 12/4/10, wbeech@flash.net <wbeech@flash.net> wrote:
>> the 'hidden' peg is in an odd spot but works and fits fine.
>
> ...can you pictorially share this location?
Here is where the inny peg is on mine:
http://members.cybertrails.com/~ahwahnee/TR3%20Stick%20Cover%201.JPG
To use it the female LTD is installed upside down & inside out:
http://members.cybertrails.com/~ahwahnee/TR3%20Stick%20Cover%202.JPG
I almost never undo that fastener since when I use the tonneau I just undo
the rest of the stick cover and let it hang down back there. I do use a
combination of towels & foam to take up some of the slack in the fitted
cover:
http://members.cybertrails.com/~ahwahnee/TR3%20Stick%20Cover%203.JPG
Stick cover in place:
http://members.cybertrails.com/~ahwahnee/TR3%20Stick%20Cover%204.JPG
Geo
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|
