Go to your local automotive paint store and get a quart of 'Etch Primer",
this will protect it until you are ready. Then you can sand it, prime it,
paint it when you are ready. I like the Nason brand but there are others.
Bill
Bill Beecher
'58 TR3A TS/30766L "Tarbaby"
'62 TR3B TCF/2549L " Aunt B" (in rehab)
www.triumphowners.com/1566
'68 Land Rover Series IIa 88" "The Beast"
"If you think you have everything under control... You're driving too slow"
M.Andretti
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Malcolm
Sent: Saturday, January 05, 2013 11:16 AM
To: triumphs@autox.team.net
Subject: [TR] Storing sheet metal (fenders)
Hi List,
I've been lurking for a while now - some of you may remember me from the
late '90s. Life has interrupted but I still have my TR4.
I now also have the opportunity to buy a pair of rear fenders. However,
they would have to be stored in my (unheated) workshop or the attic of our
house, for a few months to a year, while I figure out how to get the TR4
into the workshop for a proper restoration.
What do people recommend for treating the sheet metal for storage? Oil,
grease, waxed paper, really big ziploc bags?
Thanks in advance!
-Malcolm
'62 TR4 (CT10339L)
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|