[TR] Order of Engine Assembly

[terryrs at comcast.net (terryrs at comcast.net)]

When reassembling the engine, I seem to have put the number 2 liner in the #1 
engine slot, and #2 into #1.  I hate to take it apart because I'm afraid I'll 
bugger up the figure 8 gaskets.

So...new bearings, new rings, honed liners,ground crankshfat...just how 
critical is it that these go in the same holes?  Isn't it the same as if I were 
buying new liners?

Terry Smith, '59 TR3A  TS 58667
New Hampshire