Hi Bob,
I have a TR4A with HS6's, and Moss' 734-025 works for me.
I assume your choke control is on the far right hand side of the center
plinth. Correct? The DPO may have cut the cable currently in the car to make
it fit. It fact I need to cut mine back a little since it hits the bonnet.
Johnnie
> -----Original Message-----
> From: triumphs-bounces at autox.team.net [mailto:triumphs-
> bounces at autox.team.net] On Behalf Of Bob Labuz
> Sent: Tuesday, March 13, 2012 3:12 PM
> To: Triumphs at autox.team.net
> Subject: [TR] SU HS6 choke cable on a TR4
>
> Hi,
>
> Installing a set of HS6 carbs on my 63 4 and the existing choke cable
> is
> way too short. I looked up the part and TRF and MOSS show the same part
> # for the cable.
>
> I need something that is about 6 to 8 inches longer because it will
> have
> to mount from the top . It will have to go under the rear carb and then
> arch up and then go straight down.
>
> Does anyone know what part # would work for this application?
>
> Would a dual line setup like used on the TR6 work?
>
> Now, the HS6 was installed on the later TR4A. Wouldn't they have had
> the
> same issue? So wouldn't the cable for the 4A be a different part # than
> the 4?
>
> Thanks,
>
> Bob
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/pdonnel1 at san.rr.com
|