triumphs
[Top] [All Lists]

[TR] Update on TR3A from 2 weeks ago

Subject: [TR] Update on TR3A from 2 weeks ago
From: tony at tonydrews.com (Tony Drews)
Date: Sun, 11 Dec 2011 07:44:48 -0600
References: <CF868098ED1B4549BF841862002081C4@AlexPC>
I wonder if the head re-torque after warming up the engine hadn't 
been done.  I'm always amazed at how much movement I get on the 
second torqueing.  Also, 0.006" difference in liner protrusion 
between two adjacent liners is not ideal.  A little difference from 
side to side will work as long as it's consistent.  0" protrusion 
isn't great.  You may want to try Randall's trick of the thin copper 
wire glued / soldered to the head gasket.

Tony Drews

At 08:19 PM 12/10/2011, Alex wrote:
>Today a friend and I pulled the head on my 59 TR3.
>
>  This is the car with the condensation on the carbs, oil dripping from the
>engine vent tube and the cloud of white smoke out the back upon
>acceleration..
>
>Here's what we found by pulling the head off.
>   1.. The head bolts appeared to be very loose compared to what force it took
>to torque the head bolt to 105 lbs. To torque we did this in three passes
>starting at 40 lbs then 70 then 105 lbs.
>   2.. The head itself lifted right up after applying a large screw driver
>under the thermostat housing. After wedging a flat screw driver between the
>head and the block at the rear of the head, (distributor side) the whole head
>was free. Lifted it right off. NO string, or pounding or difficulty at all.
>   3.. The head gasket appeared not to be damaged anywhere.
>   4.. The sleeves showed a gap to the block from anywhere between .000" and
>.006", with the average around .005"
>   5.. The cylinder walls were super clean with no marking anywhere. Still had
>nice cross hatching from the hone.
>   6.. The # 3 cylinder with the 55-60 lbs compression showed that the intake
>valve was wet....with gas/oil. Took this one out and inspected the seat.
>Perfectly clean. Cleaned up the bottom and top of the valve and reinstalled.
>   7.. All valves looked normal.
>   8.. The book calls for coating the gasket with wellseal. Used blue hylomar
>by permatex.
>So we cleaned the head and block deck. Installed a new head gasket after
>applying hylomar to both sides of the gasket. Torgued the head. Tomorrow we
>will install the valve train and check compression to see if there is any
>improvement in #3 cylinder.
>
>Our initial belief is the head was not torqued to spec. We'll see tomorrow.
>
>Note-hylomar at Advanced Auto sells for $11.99 per 1-1/2oz tube. They are
>discontinuing it and is now on sale for $1.98/tube. That is if they have it.
>Had to go to two store.
>
>Stay tuned.....
>Alex Manzo
>59 TR3A
>
>** triumphs at autox.team.net **
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/triumphs/tony at tonydrews.com

<Prev in Thread] Current Thread [Next in Thread>