triumphs
[Top] [All Lists]

[TR] Ignition coil question..

To: <triumphs@autox.team.net>
Subject: [TR] Ignition coil question..
From: "Dave Connitt" <dconnitt@fuse.net>
Date: Sat, 5 Feb 2011 19:38:42 -0500
Hi List,
Like practically everyone on this list, my garage is way too cold to venture 
into for at least a couple of months so.. Here I sit writing this email.
Today I discovered a bunch of old Classic Auto Restorer magazines from back in 
the late '90's. Besides the date on the cover, there are no references to email 
or website addresses which is kind of wierd. 
Anyway, I was re-reading an article explaining breaker point ignition 
fundamentals and troubleshooting. The writer made some interesting points ( 
sorry for the pun) regarding reasons a coil may die.The writer states that 
there are two main causes of coil failure, moisture entering the coil and heat. 
The moisture will usually enter the coil at the seal between the case and the 
top. Usually caused by corrosion at the joint. Heat is another matter, This is 
usually the result of a voltage higher than 8 VDC in a 12 volt system. The 
writer stated that a resistor in series with the ignition switch in the "ON" 
position will allow the full battery voltage (usually slightly more than 12V) 
during start only. Once the engine startes and the ignition switch Triumphs 
have the coil mounted to the side of the block! Short of the exhaust manifold, 
I can't think of any place hotter to mount the coil.
Well, it was an interesting article.. Wait, the Top Gear episode where the boys 
travel from Florida to New Orleans and practially get killed after painting 
slogans offensive to southerners on their cars!!!
Dave Connitt
'67 TR4A IRS
http://home.fuse.net/davestr4a
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>