I think all the bolt dimensions and torque values are listed in the
front of the Service Manual ...
>
>
>I don't have easy access to that area at this time but from memory, the inside
>bolts are 3/8" 24 and should be about 1.5" or so in length with about 1" of
>thread. They are fitted with a single lock washer.
>
>The nuts under the shock tower are just regular 3/8" nuts welded underneath.
>They are not the captive nuts.
>
>Since the fulcrum is about 1/2 ", I am guessing you should see about 1/4 to
>1/2 inch of bolt protruding the nut but I have never looked.
>
>If the bolts wont get tight with a single washer, try re-tapping the nut but
>make sure you work slow with a lot of cutting oil.
--
"Thinking is the hardest work there is. That's why so few people
undertake it." - Henry Ford
Bill Pugh
1957 TR3
"Casper"
TS16765L
Wallace, CA
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|