triumphs
[Top] [All Lists]

Re: [TR] leaf springs-Polyethylene plastic-teriann wakeman

To: triumphs@autox.team.net
Subject: Re: [TR] leaf springs-Polyethylene plastic-teriann wakeman
From: "TeriAnn J. Wakeman" <tjwakeman@gmail.com>
Date: Tue, 09 Nov 2010 19:32:48 -0700
On 11/9/10 6:39 PM, Gary Nafziger wrote:
> Listers,
> I saved a post from Teriann from long long ago concerning leaf springs and the
> use of Polyethylene plastic strips between leaves rather than cleaning up and
> using grease.  TeriAnn had used that method and was very happy with it.


Here's a quote from one of my web pages:

"the next step is to minimize the friction between the individual 
leaves. I like UHMW (ultra-high molecular weight) Polyethylene plastic.

This plastic provides a low friction surface, similar to Teflon tape, 
but with a much higher abrasion and puncture resistance. It was designed 
specifically for commercial use on chutes, packaging lines, slides, and 
anywhere high pressure metal to metal sliding contact occurs. It also 
provides sound dampening, eliminating squeaks and rattles caused by 
adjacent parts movement. The plastic's temperature range is -40 to +225 
degrees F.

The plastic tape I like is 0.005" thick, comes on a 3 inch wide roll and 
has 1.5 mils of acrylic adhesive. It can be purchased from McMaster Carr 
(http://www.mcmaster.com/) and is part number 76445A24 (You can do a 
part number search on their site to find the tape).

You disassemble the spring pack and stick the tape to the top side of 
each individual leaf, except for the top leaf of course. This tape 
virtually eliminates the friction between adjacent leaves in the leaf 
pack and dramatically increases the spring's ability to react to bumps 
in the road."

I wrote the above for Series Land Rovers which have 3 inch wide leaf 
springs.  The plastic has been between the springs for 11 years now. 
The strips are a bit ratty around the ends but are still hanging in 
there after a lot of washboard road driving in the Land Rover. Spring 
flex is still better than new stock.

I have not had my TR3's rear springs apart since trying it on the Land 
Rover.  It however on my to do list when I get around to pulling the 
springs.

Teriann
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>