In a message dated 5/6/2010 9:06:18 AM Central Daylight Time,
aribert@c3net.net writes:
> Without that, you could try to run the motor w/o the pulley and hold a
> file to it (place the file so that the shaft will pull the file *away*
> from you) and knock down the high spots. Not having seen the damage, I am
> guessing that the motor shaft is already a bit undersize before you even
> knock down the high spots. I think you will still have a shaft that is
> undersize relative to your pulley bore and one that will not run true.
>
You could try to back fill the recesses with JB Weld and then file back
down to the origial size.
Dave
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|