Gary,
Did you get new needles for the carbs during your overhaul?
I bought a carb rebuild kit from Moss, and the needles were both different
sizes, and way to fat... I couldnt idle without choke and it ran rough when
they were in. Might want to put your old needles back in if you have them
(and if you replaced them).
- Aldwyn
At 02:43 PM 6/6/2009, Gary Nafziger wrote:
>Just a note here for some possible ideas. I'm having trouble getting my tr-6
>to run right since overhaul. At present won't idle and seems to run well
>without miss at high rpm's. I finally took it to local mechanic familiar with
>old cars's and zenith carbs. fuel pump is putting out around 2 lbs. valves
>set ok............no vacum leaks. However one piston on carbs doesn't raise
>as high as other.........(engine off). any quick and dirty ideas?
>
>gary n.
>_
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|