triumphs
[Top] [All Lists]

Re: [TR] valve spring removal

To: todd Richmond <twr@frii.com>,triumphs@autox.team.net
Subject: Re: [TR] valve spring removal
From: Tony Drews <tony@tonydrews.com>
Date: Sat, 06 Jun 2009 19:22:47 -0500
The compressor should push down on the retainer which will compress 
both springs.  You may need to give it a rap with a hammer (rubber) 
to break it loose from the collar pieces.  When compressed enough you 
should be able to remove each half of the retaining collar, then 
release the pressure on the springs.

Pictures here:
http://www.tonydrews.com/2007-8Rebuild/DSCN0182.JPG
http://www.tonydrews.com/2007-8Rebuild/DSCN0183.JPG

They are near the bottom of this page: 
http://www.tonydrews.com/2007-8Rebuild/2007-8RebuildP2.htm

- Tony Drews

At 06:41 PM 6/6/2009, todd Richmond wrote:
>Hi,
>
>My son and I are scratching our heads trying to figure out how to get
>the
>double valve springs removed off a TR3.
>
>I've got a spring compression tool, and I've been able to compress the
>outer spring.  At that point I was expecting to be able to release the
>cotter
>pieces and/or the collar, but it doesn't seem to be quite that easy.
>
>I would appreciate any help on how to do this.  Google has failed me,
>and
>I'm a real newbie at this part.  :)
>
>Thanks,
>
>Todd Richmond
>Fort Collins, Colorado
>1959 TR3A TS54425L
>_______________________________________________
>
>Support Team.Net  http://www.team.net/donate.html
>
>This list supported in part by the Vintage Triumph Register
>http://www.vtr.org
>
>
>Triumphs@autox.team.net
>http://autox.team.net/mailman/listinfo/triumphs
>
>You are subscribed as tony@tonydrews.com
>
>http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>