> I have just replaced a blown head gasket and now have a smoking TR3 !
Where was it blown ?
> After filling it with fresh oil, I started it up and there
> was lots of
> smoke .. it was not blue or too smelly.
>From exhaust or crankcase breather ?
> After 1/2 hour of running, it was till smoking the same amount.
Idling or being driven ?
> I checked the dipstick and I did notice tiny bubbles (maybe three or
> four on the dip-stick) ... must be residue of water that was stuck in
> the pan and other hidden storage areas.
IMO if you can still see water after 1/2 hour, you've still got a water
leak. What happened to the level in the radiator after cooling ?
> - Do you think just changing the oil will fix things?
Seems very unlikely to me.
> - Is the tiny bit of water in the slipping by the oil rings?
Not sure of the question; should be no water either above or below the
rings.
> - Can I just run it and it will eventually burn/steam off?
Again it seems unlikely; but I guess you don't have much to lose by trying.
IMO it would be unusual for a head gasket to blow between the water jacket
and the openings to the crankcase; more likely you have a cracked head or a
leaking "Figure 8" gasket. If it is the head gasket, then most likely
something else is mechanically wrong, like the liners protrude too far or
the head/block are not flat or possibly a damaged (stretched) head stud.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|