triumphs
[Top] [All Lists]

Re: [TR] Stromberg plug o-rings

To: "'Bob Peglow'" <rpeglow@optonline.net>, <triumphs@autox.team.net>
Subject: Re: [TR] Stromberg plug o-rings
From: "Randall" <tr3driver@ca.rr.com>
Date: Sat, 24 May 2008 08:25:52 -0700
> I have searched and found reference to the o-ring for 
> Stromberg bowl bottom plug to be style/type 2-114, correct?

Can't find my note at the moment, but I'm pretty sure that's not the right
number.  -114 would indicate a 5/8" od, and the bore in the rod is much
smaller than that.

> One recommendation said use Vitron only, another said 
> Ethylene...  only.

Viton would work I believe; but I used ordinary Buna-N (nitrile rubber) as I
believe that's what the originals were (and what I had on hand).  EPDM/EPR
(Ethylene Propylene whatever) is definitely the wrong thing, IMO, as it has
poor resistance to petroleum oils.
You can read more about O-ring materials at any number of web sites,
including MMC and
http://www.epm.com/material_guide.htm

> What's the latest......... and where can I get them please?

ISTR Mine came from Harbor Freight, in one of these kits
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=2901

Bought on sale for 1/2 price; figuring that even one O-ring used from it
would pay for the kit.  It's been handy many times since then.  In fact,
just a few days ago, I tried several O-rings from the kit until I found the
one that fit my bearing extractor (holds the tip to the forcing screw).

Randall
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>