When mine started doing that I referred to the owners manual...said to bleed
it. I did and it resolved the problem.
----- Original Message -----
From: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>
To: <triumphs@autox.team.net>; "'6-Pack'" <6pack@autox.team.net>
Sent: Friday, March 07, 2008 9:08 AM
Subject: [TR] Hydraulic Jack Question
> What causes a jack or even an engine crane to stop holding a position and
> settle back down after a while? Is it low fluid or a bad gasket or a
> combination of things? I know that there's an industry standard for how
> much
> one can drop over an x period of time. But I'm talking about a matter of
> minutes with or without a load on it?
>
> Bob Danielson
> 1975 TR6 CF38503U
> Running w/ Throttle Body Injection
> http://tr6.danielsonfamily.org
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as eoot@citlink.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|