triumphs
[Top] [All Lists]

Re: [TR] Turning engine backwards?

To: "Randall" <tr3driver@ca.rr.com>, "'list Triumph'" <triumphs@autox.team.net>
Subject: Re: [TR] Turning engine backwards?
From: "Skip Gurnee" <skip47@powernet.net>
Date: Sun, 9 Dec 2007 12:45:44 -0800
Hi Paul-
Just a minor clarification of Randall's note- the cam timing chain always
has a little slop in it, and if you turn the engine backward, you take up
the slack in the backwards direction, which could be several degrees off,
depending on the age and wear of the chain and pulleys.  So when you turn
the engine backward, turn it a little farther than you need, (10 degrees is
plenty) and then forward again to reestablish correct timing.
Skip Gurnee
64 TR4
65 TR4A

> > Will it do the motor definite harm if I go an inch (turning
> > the fan) in the wrong direction?
>
> No Paul, it won't damage anything at all.  It just means that you will not
> get an accurate reading if you try to set the ignition timing after
turning
> the engine backwards.
>
> I turn mine backwards all the time, when setting the valve lash.  In that
> case, I'm not worried about exact timing between crankshaft and camshaft,
so
> I'm not worried about backlash in the timing chain.
>
> Randall
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>