Al,
Got my 4A body on a dolly right now as I do all of the body work before its
off to the painter.
I highly recommend removing the doors and bracing with bars.
I had some made of angle iron which simply bolt on using holes that are
already there (windscreen mounts in front, something near door in back).
Limited by floor space, I ended up constructing a pulley system so I could
lift and store the body overhead while working
on the chassis, etc. below. Now that the chassis/drivetrain portion of my
project is completed,
I constructed the aforementioned dolly and lowered the tub down on to it,
bars still in place.
It is wonderful to be able to easliy roll the body all over the shop!
Check out pics at:
Tub lifting at http://www.genfiniti.com/triumph/restoration/body.asp
Dolly pics at http://www.genfiniti.com/triumph/restoration/bodyRenew.asp
-----Original Message-----
From: triumphs-bounces+guy=genfiniti.com@autox.team.net
[mailto:triumphs-bounces+guy=genfiniti.com@autox.team.net] On Behalf Of Alan
Salvatore
Sent: Monday, November 05, 2007 7:21 PM
To: triumphs@autox.team.net; 6pack
Subject: [TR] Removing TR6 body from frame
Hopefully, this may be the week the frame is going to get straighten.
Though, I am not holding my breath.
After that I have to take the body off the frame.
Has anyone had any experience taking the body off with the doors left in
place?
Or is it best to take the doors off and brace the shell?
Thanks
Al Salvatore
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|