In a message dated 4/26/2006 12:16:47 AM Eastern Daylight Time,
tom623@glinenet.com writes:
> Needless to say, when I took it for a short test ride it was a major
> improvement.
Good point, Tom....it's very easy to re-assemble the entire accelerator
linkage on a TR250/6 incorrectly resulting in less than full throttle at full
down
accelerator pedal....especially after one has replaced the accelerator rod
bushings in the bulkhead!
Chip Krout
Delaware Valley Triumphs, Ltd.
Skippack, PA USA
'76 TR6 CF57822U
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|