| To: | "triumph list" <triumphs@autox.team.net> |
|---|---|
| Subject: | slave cylinder needs mastering |
| From: | "Paul Dorsey" <dorpaul@negia.net> |
| Date: | Sun, 9 Oct 2005 17:02:33 -0400 |
I am rebuilding clutch slave cylinders. I have one Lockheed and one Girling type. The Lockheed is 1 1/8" bore and the Girling is 1" bore (I think). How do I secure the Lockheed piston inside the Lockheed SC when there is NO groove for a circlip? Can I use the Lockheed SC on my '60 TR3A which I think originally was Girling? You see, my Girling SC's piston is stuck inside of it! Thanks, Paul Dorsey 60 TR3A === This list supported in part by The Vintage Triumph Register === http://www.vtr.org |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Stupid compression ratio question, Wayne Lee |
|---|---|
| Next by Date: | Head Removal Part II, MotoPsyche |
| Previous by Thread: | TR4/4A/250 Hardtop Seal question, Jeff Tedder |
| Next by Thread: | Re: slave cylinder needs mastering, THOMAS FANSHER |
| Indexes: | [Date] [Thread] [Top] [All Lists] |