In a message dated 8/9/2005 10:19:16 AM Central Standard Time,
twakeman@razzolink.com writes:
> I have one of those, along with a TR6/GT6 gauge in the Land Rover
> watching over the water temperature in a Ford 302 (How's that for a
> mixture). Ideally I would like to gauge to read just a tad lower so the
> needle was centered when the 180 degree thermostat opened.
>
If that's all you want try adding a small value resistor in series with the
sensor. Start with a 47 Ohm 1/4 and see if you like that reading. Go up or
down from there.
Dave
|