| To: | Joe Curry <spitlist@cox.net> |
|---|---|
| Subject: | Alternative wheel studs. |
| Date: | Fri, 30 Jul 2004 22:26:04 -0700 |
| Cc: | "'Randall'" <tr3driver@comcast.net>, Triumphs@autox.team.net |
| References: | <000401c47598$452ecbb0$a9fea8c0@Medifax> |
When converting my TR front hubs to a Ford 4 1/2 X 5 inch bold pattern
my machinist used 1/2" X 2" allen set screws for wheel studs. The holes
in the hubs were threaded and then the allen screw is threaded through
the hole far enough to allow a jam nut on the rear of the hub. I also
used red locktite on the installation. The set screws are grade 8 so
there is no compromise in strength.
--
Best regards,
Tom
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: TR 4A IRS Twitch, Greg Solow |
|---|---|
| Next by Date: | Alternative wheel studs., T. S. White |
| Previous by Thread: | aircraft writeups, Unknown |
| Next by Thread: | Alternative wheel studs., T. S. White |
| Indexes: | [Date] [Thread] [Top] [All Lists] |