I saw the subject line and couldn't help but think, "I'll bet that hurt!
:)
Joe
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net] On Behalf Of Scott Suhring
Sent: Saturday, September 20, 2003 8:33 PM
To: Michael Hutchinson; The Usual Suspects; 6pack@autox.team.net
Subject: RE: captured nuts on chassis
Michael:
If you are talking about the nuts that are held in place by the boxed
metal,
these are available from TRF and MOSS. All you need to do is cut out
the
old metal cage and then put in a new nut into the new cage and spot weld
to
the chassis in the correct position.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On
Behalf Of Michael Hutchinson
Sent: Monday, October 20, 2003 2:28 PM
To: The Usual Suspects; 6pack@autox.team.net
Subject: captured nuts on chassis
Does anyone know of a source for the captured nuts that are welded into
the
chassis of my 6? I have a few that need to be replaced before I have it
sand
blasted. Just let me know. Thanks in advance.
Michael Hutchinson
'71 TR6 (Lazarus)
|