From tech bulletin T-65-19, the correct procedure to fold the top
includes:
"release the two side draft vent clips from the windshield post"
Where/what are these? The are two little flaps at the front corner of
the fabric that were riveted to the front of the frame.
It then goes on to say:
"make sure to release the two draft vent cups from the second hoodstick
rail"
Again, what is this? There is a flap on the top that was riveted to
the rail. Should that be attached with snaps or something?
Any help or insight would be appreciated!
--
Darrell Walker
66 TR4A IRS CTC67956L
Vancouver, WA, USA
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|